SR 725 ''LIGHT''
Electronic control unit with Micro-process and permanent memory. N.2 heating programs: one program for TRADITIONAL coatings, who contains up to 3 phases (with choice of Temperature, Temperature increase rate expressed in °C per minute and holding time) and one program specifically studied for FAST coatings.
Ignition delay up to 100 hours.
It comes in 3 different versions depending on the size: S, M, and L.
All versions can be equipped with flue fume aspiration (SR731).Fire Light 720 S - chamber cm 16x16x10
Fire Light 720 M - chamber cm 18x23x11,5
Fire Light 720 L - chamber cm 23x30x15
SR 731 Fumes Aspiration Flue (Optional for all versions)
SR 311 Cylinder Clamp
SR 732 Dewaxing plate Small
SR 734 Dewaxing plate Medium
SR 736 Dewaxing plate Large
SR 750 ''IN FIRE''
PERFORMANCE AND USE
The oven as said earlier can memorise up to 7 pre-heating cycles (or programs) which are kept in the memory until the operator decides to modify them. Each program contains 4 phases and for each phase it is possible to set 3 variables: temperature, increase rate, holding time. It is also possible to set an Ignition delay and the fumes aspiration fan Off temperature (fume chimney). Furthermore it is possible to set a final temperature holding time at the end of the cycle: this is to keep the cylinders at a certain temperature and allow some time for the operator to be ready with the next work.Fire 750 S - chamber cm 16x16x10
Fire 750 M - chamber cm 18x23x11,5
Fire 750 L - chamber cm 23x30x15